Sharp MX-M314N Operation Guide - Page 45
Interior - manual
View all Sharp MX-M314N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
INTERIOR BEFORE USING THE MACHINE (15) (16) (17) (18) (19) (20) (15) Toner cartridges These contain toner for printing. When the toner runs out in a cartridge, the cartridge must be replaced. REPLACING THE TONER CARTRIDGES (page 1-51) (16) Upper right side cover If a paper misfeed occurs while outputting to the job separator or the finisher (sold separately), open this cover to remove the misfed paper. Paper misfeed in the upper exit area (when a job separator/finisher (MX-FN23) is installed) (page 8-10) (17) Fusing unit Heat is applied here to fuse the transferred image onto the paper. Caution The fusing unit is hot. Take care not to burn yourself when removing a paper misfeed. (18) Right side cover Open this cover to remove a misfeed. (19) Paper reversing section cover This is used when 2-sided printing is performed. Open this cover to remove a paper misfeed. (20) Photoconductive drum This is a drum with a photoconductor coating. The images are produced on this photoconductor. (The photoconductor is green.) Do not touch or damage the photoconductive drum. This may cause a defective image. (21) Handle Pull this out and grasp it when moving the machine. (21) (22) (23) (24) (22) Right cover of paper drawer (when a paper drawer is installed) Open this to remove a paper misfeed in tray 3 or tray 4. (23) Paper tray right side cover Open this to remove a paper misfeed in tray 1 or tray 2. (24) Bypass tray Use this tray to feed paper manually. When loading a large sheet of paper, be sure to pull out the bypass tray extension. LOADING PAPER IN THE BYPASS TRAY (page 1-33) 1-4 Contents