Sharp NP-PH3501QL User Manual - NEC - Page 141

WIRED LAN 5. Using On-Screen Menu INTERFACE PROFILES DHCP IP ADDRESS SUBNET MASK GATEWAY AUTO DNS DNS CONFIGURATION RECONNECT To configure the LAN port, select [LAN]. - To configure the HDBaseT port, select[HDBaseT]. • The settings for the wired LAN can be recorded in the projector - memory in two ways. • Select [PROFILE 1] or [PROFILE 2] and then do settings for [DHCP] and the other options. After doing this, select [OK] and press the ENTER button. This will store your settings in memory. • To recall the settings from memory: After selecting [PROFILE 1] or [PROFILE 2] from the [PROFILES] list. Select [OK] and press the ENTER button. Place a check mark to automatically assign an IP address to the - projector from your DHCP server. Clear this check box to register the IP address or subnet mask number obtained from your network administrator. Set your IP address of the network connected to the projector when [DHCP] is turned off. NOTE: • System IP addresses such as 192.168.254.XXX cannot be set. Up to 12 numeric characters Set your subnet mask number of the network connected to the Up to 12 numeric projector when [DHCP] is turned off. characters Set the default gateway of the network connected to the projector Up to 12 numeric when [DHCP] is turned off. characters Place a check mark to automatically assign the IP address of your DNS server connected to the projector from your DHCP server. Clear this check box to set the IP address of your DNS server connected to the projector. AUTO DNS can be set for the HDBaseT port only. Up to 12 numeric characters Set the IP address of your DNS server on the network connected Up to 12 numeric to the projector when [AUTO DNS] is cleared. characters Retry to connect the projector to a network. Try this if you have - changed [PROFILES]. 124