Singer 9985 Quantum Stylist TOUCH Instruction Manual - Page 84
Darning/free-hand, Embroidery
View all Singer 9985 Quantum Stylist TOUCH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
DARNING/FREE-HAND EMBROIDERY No. 1.Center needle position Darning/Embroidery Foot A. ATTACHING THE DARNING/ EMBROIDERY FOOT 1. Lower the feed dogs by moving the drop feed lever to the left. 2. Remove the presser foot and holder. (See page 14) 3. The arm of darning/embroidery foot should rest on the shaft of the needle clamp screw. 4. Slide the plastic attaching head from your left to right so that it is fitted into the presser bar. 5. Tighten the presser foot screw. B. DARNING 1. Place fabric under foot and lower the presser foot lifter. 2. Grasp fabric firmly in front and back of area to be stitched. Start sewing, moving fabric by hand forward and backward with an even motion, stitching in closely spaced rows over the hole or worn area. 3. When the area is filled with new stitches, move fabric from side to side in a similar manner to weave or reinforce the stitching. Note: a. Reinforce open areas with an underlay; baste underlay in place before darning. C. FREE-HAND EMBROIDERY 1. Outline the design for embroidery on the surface of the fabric. 2. Place design to be embroidered between the two sections of embroidery hoop. Note: Embroidery hoop is not included with this machine. 3. Set embroidery hoop under needle and lower the foot. 4. Start the machine at medium speed, guiding hoop carefully so needle moves along line of the pattern. D. After darning or free-hand embroidery Raise the feed degs by moving the drop feed lever to the right. Then, turn the hand wheel toward you one complete revolution. 84