Sony CCD-FX511 Primary User Manual - Page 73
Troubleshooting
View all Sony CCD-FX511 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Troubleshooting If you run into any problems using the camcorder, use the following table to troubleshoot the problem. Should the difficulty persist, unplug the unit and contact your Sony dealer or local authorized Sony service facility. Symptom Cause Corrective actions The power does not turn on. The battery is not attached. Attach the battery. The battery is used up. Use a charged battery. The AC power adaptor is not connected to a wall outlet. Connect the adaptor to a wall outlet. The power turns off. While being operated in CAMERA Turn down the STANDBY mode, the camcorder has been in switch, and turn it up again. Pause mode for more than 5 minutes The battery is used up. Use a charged battery. The battery pack is quickly The ambient temperature is too low. discharged. The battery pack has not been charged fully. - Charge the battery pack again. The START/STOP button The tape is stuck to the drum. does not operate. The tape is at its end. Eject the tape. Rewind the tape or use a new one. The POWER switch is set to VTR. Set it to CAMERA. The tab on the tape is out (red). Use a new tape or slide the tab. The tape cannot be removed from the compartment. The battery is used up. Use a charged battery or the AC power adaptor. No function except for tape Moisture condensation has occurred. Remove the tape and do not ejection works. (See page 61.) use the camcorder for at least an hour. The tape does not move when a tape transport button is pressed. The POWER switch is set to CAMERA Set it to VTR. or OFF. The tape is at its end. Rewind the tape or use a new one. The autofocusing function FOCUS was not set to AUTO when does not work. recording. Shooting conditions are not suitable for autofocusing operation. (See page 35.) The image on the viewfinder The viewfinder lens is not adjusted. screen is not clear. Set FOCUS to AUTO. Set FOCUS to MANUAL to adjust the focus manually. Adjust the viewfinder lens. A vertical band appears The contrast between the subject and when a subject such as background is too high; the camera is lights or a candle flame is not malfunctioning. - shot against a dark background. The playback picture is not EDIT is set in the direction of the clear. arrow. Set EDIT in the opposite direction of the arrow. The channel or input for the Select correctly. camcorder is not selected on the TV. The picture is noisy. The video heads may be contaminated. Clean the heads using the Sony V8-25CLH (see page 62) cleaning cassette. When the TV is connected to the camcorder using the VIDEO/AUDIO jacks, the picture on the TV is not clear or moves vertically. The IN/OUT selector is set to OUT. Set it to IN. 73 Additional Information