Sony HXCU-FB80 Operating Instructions - Page 10

Rear Panel a "Memory Stick" slot For service use only. b LAN jack (RJ-45, 8-pin) Connects to a LAN hub (10BASE-T/100BASE-TX), when using a network connection, via a LAN cable (shielded type, category 5 or higher). CAUTION For safety, do not connect the connector for peripheral device wiring that might have excessive voltage to this port. Follow the instructions for this port. c HD PROMPTER (HD teleprompter connectors) (BNC type) When a camera that supports an HD teleprompter function is connected to the CAMERA connector, the HD-SDI signal input on this connector is output from the SDI I/O connector of the camera. Note Input an HD-SDI signal having frequency synchronization with the camera control unit. d SLOT2, SDI OUTPUT 1 to 4 (4K/3G/HD TRUNK output) connectors (BNC type) Outputs the camera signal as 12G SDI signal, 3G SDI signal, or 1.5G signal (HD TRUNK only). e RETURN INPUT SDI1, SDI2, VBS1, VBS2 (VBS/SDI return video) connectors (BNC type) Inputs the VBS return video signals (2-system), HD SDI or SD SDI return video signals (2-system). f AUDIO OUTPUT CH-1, CH-2 connectors (XLR 3-pin) Outputs audio signals from the camera AUDIO 1 IN and AUDIO 2 IN connectors. g CAMERA connector (optical fiber connector) Connect to the target camera or CA-FB70 HD Camera Adaptor. When you use an optical composite cable for connection, power supply, all camera signals, such as control signal, video signal and audio signals can be transmitted. When you use only single-mode optical fiber cables for connection, all signals (except power supply) can be transmitted by a pair of single-mode optical fiber cables. For details about pin assignment, see "CAMERA connector" (page 37). Note If the terminations of the single-mode optical fiber cable or optical composite cable are contaminated with dust, etc., transmission errors may occur. Be sure to replace the cap that came with the cable over the termination when a cable is not in use. h AC supply input connector Connects to the AC supply via the specified power cord (optional). A plug holder (optional) can be used to secure the power cord to the CCU. i REFERENCE (reference input) connectors (BNC type) IN: Inputs an HD tri-level reference sync signal or SD reference sync signal (black burst signal) for external sync. OUT: The input signal is output from the other connector as-is (loop-through output). If the loop-through output is not used, it is automatically connected to a 75 Ω terminator. j PROMPTER (teleprompter input) connectors (BNC type) IN: Inputs the VBS signal for the teleprompter. OUT: The input signal is output from the other connector as-is (loop-through output). If the loop-through output is not used, it is automatically connected to a 75 Ω terminator. k REMOTE connector (8-pin) Transmits and receives control signals from the RCP-1000series Remote Control Panel via a CCA-5 cable (optional). It also supplies power when connected to an RCP-1000-series Remote Control Panel. l VBS 1, 2 (composite video signal 1, 2) connectors (BNC type) Outputs (2-system) the camera signals in composite signal format. m SLOT1, SDI OUTPUT 1 to 4 connectors (BNC type) Outputs the camera signals in HD SDI or SD SDI signal format. The SDI OUTPUT 3 and SDI OUTPUT 4 connectors can also output signals with superimposed character or marker display. n PIX (picture monitor output) connector (BNC type) Outputs a video signal for a picture monitor. It can also output a signal with superimposed character display. o SYNC (sync signal output) connector Outputs a sync signal for connection to the sync signal input connector of a waveform monitor or picture monitor. 10