Sony HXCU-FB80 Operating Instructions - Page 18

CAM MIC Gain CH2 (REAR): Amplifier gain for a microphone connected to the camera AUDIO 2 IN connector. Network diagnostics Page 1 *Network Diag 1/3* 7/14 MacAddress:000000-000000 Auto Negotiation: ON Connection Speed:100M Duplex Mode :HALF Link Status :OK MacAddress: MAC address stored in CCU EEPROM Auto Negotiation: Auto negotiation setting Connection Speed: Connection speed setting Duplex Mode: Communication method setting Link Status: Network connection status Page 2 *Network Diag 2/3* 8/14 CNS Mode :BRIGDE CCU No. :1 CNS Mode: REMOTE and LAN connectors mode setting CCU No.: CCU number setting Page 3 *Network Diag 3/3* 9/14 IP Address 0. 0. 0. 0 Subnet Mask 0. 0. 0. 0 Default Gateway 0. 0. 0. 0 IP Address: CCU IP address setting Subnet Mask: CCU subnet mask setting Default Gateway: CCU default gateway setting CCU AT board diagnostics *AT Diag* 10/14 SLOT2-1&2:4K/59.94P 2SI SLOT2-3&4:4K/59.94P 2SI SDI OUT:1 2 3 4 STATUS1 OK OK OK OK STATUS2 OK OK OK OK PLD Status :OK AT :1.00 AT POWER :OK SLOT2-1&2: SLOT2 SDI OUTPUT 1/2 connector output format selection SLOT2-3&4: SLOT2 SDI OUTPUT 3/4 connector output format selection SDI OUT STATUS: SLOT2 SDI OUTPUT1/2/3/4 status PLD Status: PLD status PLD AT: AT-PLD version AT POWER: AT board power supply status CCU DPR board diagnostics *DPR Diag* 11/14 Reference :HD 4K/HD CB :BAR 16:9(100%) SD CB :SMPTE PLD Status:OK SY :1.00 POST :1.00 IIC :OK DPR POWER:OK Reference: Reference signal setting HD CB: HD color bar setting SD CB: SD color bar setting PLD Status: PLD status PLD SY: SY-PLD version PLD POST: POST-PLD version IIC: IIC bus control status DPR POWER: DPR board power supply status Front panel diagnostics *Front Panel Diag* 12/14 Assignable/Custom SW1 :CAM POWER SW2 :5600K VOLUME :SD DTL Level SW Bright:Normal IIC :OK Assignable/Custom SW1: Function assigned to the SW1 button Assignable/Custom SW2: Function assigned to the SW2 button Assignable/Custom VOLUME: Function assigned to the CUSTOM knob SW Bright: Button lights LED brightness setting IIC: IIC bus control status 18