Sony HXCU-FB80 Operating Instructions - Page 33

NETWORK SETTINGS menu NETWORK SETTINGS Page name Page No. N01 Item IP ADDRESS SUBNET MASK DEFAULT GATEWAY SET N02 AUTO NEGOTIATION CONNECTION SPEED Settings 0.0.0.0 to 255.255.255.255 0.0.0.0 to 255.255.255.254 0.0.0.0 to 255.255.255.255 ON, OFF 10M, 100M DUPLEX MODE HALF, FULL LINK CONDITION (DOWN), (UP) N03 SET CNS MODE LEGACY, BRIDGE, PC CONTROL, MCS CCU NO N04 MASTER IP ADDRESS ALL RESET 0 to 96, A to Z 0.0.0.0 to 255.255.255.255 Description Displays IP address Displays subnet mask Displays default gateway A "SET OK?" message is displayed. Press ENTER again to confirm the change. (Execute by ENTER) Select whether to automatically set the connection speed and communication system according to the device connected. Connection speed selection 10M: 10BASE-TX 100M: 100BASE-TX Available only when OFF is selected in AUTO NEGOTIATION Communication system selection HALF: Half-duplex communication FULL: Full-duplex communication Available only when OFF is selected in AUTO NEGOTIATION Displays connection status (display only) (DOWN): Connection failure (UP): Connection successful A "SET OK?" message is displayed. Press ENTER again to confirm the change. (Execute by ENTER) Network connection mode selection LEGACY: External controller connected using CCA-5 cable only BRIDGE: External controller connected using point-to-point LAN cable PC CONTROL: HZC-RCP5 connected using LAN cable MCS: Mode for control via LAN cable from a camera network master device, such as a master setup unit (for example, MSU-1000) CCU number settings 0 to 24 when CNS MODE is set to MCS Displays the PC IP address in PC CONTROL mode A "NET SETTINGS RESET OK?" message is displayed. Press ENTER again to reset NETWORK SETTINGS menu items to factory default values. (Execute by ENTER) 33