Sony KV-32XBR96S Primary User Manual - Page 74

Using the Programmable Remote Commander Operating a cable c nverter box Follow these instructions to set the manufacturer's code, which will enable you to operate a connected cable converter box with the pre-programmed Remote Commander. Example: Operate a connected Zenith cable converter box. Remote Commander (Outer panel) o X80 t) OANT/Aux D(cISP=LAYDOAPPIP coos SET M9EMoODKIITAL DISPLAY MEMO VOL to r 1 Set the TV/CABLE BOX selector to CABLE BOX. TV • • CABLE BOX QED miss Notes • If more than one code number is listed, try entering them one by one, until you come to the correct code for your equipment. • If you enter a new code number, the code number you previously entered at that setting is erased. • In some rare cases, your equipment may use a code that is not provided with this Remote Commander and you may not be able to operate your cable converter box with the supplied Remote Commander. In this case, use the equipment's own remote control unit. 74 I Chapter 3: Using Advanced Features 2 While pressing CODE SET, press 6 and 8 (Zenith's code number - see Fig. 8) and ENTER. CODE SET A long beep sounds, indicating that the code has been set. Note If you press a wrong code, or if the code has not been set, four short beeps sound. Repeat step 2 to set the code. 3 Use the TV control buttons (POWER, 0 - 9, ENTER and CH +/-) to operate the cable converter box. CH POWER /.c."6-3' .7> To return to the normal screen Set the TV/CABLE BOX selector to TV; then use the TV control buttons to control the TV. For more details on operating the cable box Refer to the operating instructions that come with the cable box. Fig. 8: Cable box manufacturer code numbers MANUFACTURER JERROLD PIONEER SCIENTIFIC ATLANTA TOCOM ZENITH CODE 60, 61, 62, 63, 64, 65 69, 70 66, 67 71, 72 68