Sony LF-X1 LFAPC1 Software Instructions - Page 12

Pre-release version Step 4 Getting the Base Station Ready to Register Your Computer This step explains how to set up the base station before registering your remote computer with it. z Tip While you are using the NetAV function to send video from the base station, you cannot use the NetAV function from your home monitor or other computers to access the base station. For details about the NetAV function and device registration, refer to the LF-X1/LF-X5 operating instructions. 1 Set the monitor to the Home-Wireless setting. Check that appears on the monitor. 2 Select [Settings], [Base station], [NetAV Settings], and then [Register Other Monitors]. The [Register Other Monitors] screen appears. 3 Configure each setting. . (1) (2) Preparations Prior to Access from a Remote Location (1) Select [Start]. After you select [Start], the current device status changes from "Registration not accepted" to "Ready for registration" and an 8-digit password appears. Jot down the password. You will need it to register your computer to the base station. (2) If you want to allow your computers to access the home base station while you are watching TV, VCR or DVDs in "Home mode", select this check box. z Tip You can resume viewing on your home monitor in "Home mode", by selecting [Get AV], which interrupts the transmission to the computer connected through the NetAV function. 12 Step 4 Getting the Base Station Ready to Register Your Computer