Sony NEX-VG10 Handycam® Handbook - Page 81
The camcorder does not work properly.
UPC - 027242808195
View all Sony NEX-VG10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Table of contents Sample images Menu Index The setting is reset without the resetting operation. • The battery pack was removed when the power switch was set to ON. When removing the battery pack, make sure the camcorder is turned off and the access lamp is not illuminated. The camcorder does not work properly. • Turn off the camcorder. Remove the battery pack and attach it again. If the camcorder is hot, remove the battery pack, and allow it to cool down before trying this corrective procedure. • If the AC Adaptor is used, disconnect the power cord. Connect the power cord and turn on the camcorder again. If the camcorder does not work after doing these solutions, consult your Sony dealer or local authorized Sony service facility. "--E-" is indicated on the screen. • Remove the memory card, and insert it again. If this procedure does not turn off the indication, format the memory card (page 69). "Recovering data. Please wait..." is indicated on the screen, and recording stops. • Recording and deleting data has been repeated too many times on the memory card, or the memory card was formatted on another device. Save the data on the hard disk of a computer, etc., first, and then format the memory card using your camcorder (page 69). • The writing speed of the memory card you are using is not fast enough to accommodate the recording speed of movies of your camcorder. Use one of the recommended memory cards (page 87). Nothing appears on the LCD monitor and viewfinder of the camcorder. • When the camcorder is connected to a computer or another device using the USB cable, nothing appears on the LCD monitor and viewfinder. This is not a malfunction. The screen turns on when the device is disconnected. 81GB