Stihl FS 250 R Product Instruction Manual - Page 23
Mounting the Control Handle, Fitting the Throttle Cable, Throttle Cable Adjustment
![]() |
View all Stihl FS 250 R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
English / USA 14 15 8 15 14 15 : Place the secured assembly on the handle support (8) with the wing screw at the engine side. : Push the wing screw into the handle support as far as stop and then screw it down - but do not finally tighten yet. : Line up the handlebar at a right angle to the drive tube - check dimension A again. : Tighten down the wing screw firmly Mounting the Control Handle : Loosen the screw (9). The nut (10) remains in the control handle (11). : Push the control handle - throttle trigger (12) must point toward the gearbox - onto the handlebar (7) so that the holes (13) line up. : Insert screw and tighten down firmly. Fitting the Throttle Cable Do not kink the throttle cable or lay it in tight radii - make sure the throttle trigger moves freely. : Press the throttle cable (14) into the retainers (15). Throttle Cable Adjustment : Go to chapter "Adjusting the Throttle Cable". 002BA234 KN 250BA002 KN 22 FS 120, FS 120 R, FS 200, FS 200 R, FS 250, FS 250 R
![](/manual_guide/products/stihl-fs-250-product-instruction-manual-d24b1c9/23.png)