Stihl MSA 200 C-BQ Instruction Manual - Page 38

English If the red light emitting diodes glow continuously / flash A B C D A 1 light emitting Battery is too diode glows hot1) 2)/cold1) continuously red: B 4 light emitting Malfunction in diodes flash red battery 3) C 3 light emitting Power tool is too diodes glow hot - allow it to continuously cool down. red: D 3 light emitting Malfunction in diodes flash red power tool 4) 1) When charging: Charge process starts automatically after the battery has cooled down / warmed up. 3901BA041 KN 3901BA019 KN 2) During operation: Power tool cuts out - allow battery to cool down; it may be necessary to take the battery out of the power tool for this purpose. 3) Electromagnetic interference or malfunction. Take the battery out of the power tool and refit it. Switch on the machine - if the LEDs continue to flash, the battery has a malfunction and must be replaced. 4) Electromagnetic interference or malfunction. Take the battery out of the machine. Use a blunt tool to remove dirt from the contacts in the battery compartment. Refit the battery. Switch on the power tool - if the light emitting diodes still flash, the power tool is malfunctioning and must be checked by a servicing dealer - STIHL recommends an authorized STIHL servicing dealer. Light Emitting Diodes (LED) on Charger 1 The light emitting diode (1) on charger glows continuously green or flashes red. Green continuous light ... ... indicates the following: The battery - is being charged - is too hot and must cool down before charging See also "Light Emitting Diodes (LEDs) on Battery". The green light emitting diode on the charger turns off as soon as the battery is fully charged. 36 MSA 160 C, MSA 200 C