Stihl MSA 200 C-BQ Instruction Manual - Page 52

English Rollomatic E Mini guide bars Reduced kickback STIHL guide bars (with green label) Bar lengths: 25, 30, 35 cm (12, 12, 14 in.) Pitch: 1/4" P (6.35 mm) Groove width: 1.1 mm (0.043 in) Sprocket nose: 8-tooth Actual cutting length will be less than listed bar length. Saw chain 1/4" P Low kickback STIHL saw chain (with green label) Picco Micro 3 (71 PM3) Type 3670 Pitch: 1/4" P (6.35 mm) Drive link gauge: 1.1 mm (0.043 in) Chain sprocket 6-tooth for 1/4" P To comply with the 45 degree computed kickback angle requirement of Section 19.108 of UL 60745-2-13 (and Section 5.11 of ANSI/OPEI B175.1-2012), use replacement saw chains listed above or elsewhere by STIHL as conforming with those requirements when used on this model chain saw or use saw chains classified as "low kickback" in accordance with ANSI/OPEI B175.1-2012. Since new bar/chain combinations may be developed after publication of this Manual, ask your STIHL dealer for the latest STIHL recommendations. Transporting batteries STIHL batteries comply with the requirements set forth in UN-Manual ST/SG/AC.10/11/Rev.5/Part III, Subsection 38.3. Commercial air, vessel and ground transportation of lithium ion cells and batteries is regulated. The battery is classified as a UN3091, Class 9, packaging group 2 product. Shipping it, either as a complete tool or the battery, requires compliance with all applicable shipping regulations. Check with the ground, vessel, air cargo or passenger airline to determine if transport is prohibited or subject to restrictions or exemptions prior to shipping or travel. Normally, no further conditions have to be fulfilled by the user to transport STIHL batteries by road to the power tool's operating site. Check and comply with any special regulations that may apply to your situation. FCC 15 Compliance Statement for power tool and charger This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: - this device may not cause harmful interference. - this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - reorient or relocate the receiving antenna, - increase the separation between the equipment and receiver, - connect the equipment into an outlet on a circuit different from that to which the receiver is connected, - consult the dealer or an experienced radio/TV technician for help. Do not change or modify this product in any way unless specifically allowed in this manual, since this could void your authority to operate it. 50 MSA 160 C, MSA 200 C