TP-Link TL-SG3109 User Guide - Page 11
Using the CLI, 1.1 CLI Command Modes, 1.1.1 Introduction - console
UPC - 845973020484
View all TP-Link TL-SG3109 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
TL-SG3109/TL-SL3428/TL-SL3452 Gigabit Managed Switch Family CLI Reference Guide Section 1. Using the CLI This chapter describes how to start using the CLI and describes implemented command editing features to assist in using the CLI. 1.1 CLI Command Modes 1.1.1 Introduction To assist in configuring the device, the Command Line Interface (CLI) is divided into different command modes. Each command mode has its own set of specific commands. Entering a question mark "?" at the system prompt (console prompt) displays a list of commands available for that particular command mode. From each mode, a specific command is used to navigate from one command mode to another. The standard order to access the modes is as follows: User EXEC mode, Privileged EXEC mode, Global Configuration mode, and Interface Configuration mode. The following figure illustrates the command mode access path. When starting a session, the initial mode is the User EXEC mode. Only a limited subset of commands is available in User EXEC mode. This level is reserved for tasks that do not change the configuration. To enter the next level, the Privileged EXEC mode, a password is required. The Privileged EXEC mode gives access to commands that are restricted on User EXEC mode and provides access to the device Configuration mode. Page 10