TP-Link TL-SG3109 User Guide - Page 265
System Management, ping
UPC - 845973020484
View all TP-Link TL-SG3109 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 265 highlights
TL-SG3109/TL-SL3428/TL-SL3452 Gigabit Managed Switch Family CLI Reference Guide Section 22. System Management ping The ping User EXEC mode command sends ICMP echo request packets to another node on the network. Syntax ping {ip-address | hostname }[size packet_size] [count packet_count] [timeout time_out] Parameters • ip-address - IP address to ping. • hostname - Host name to ping. (Range: 1-158 characters) • packet_size - Number of bytes in a packet. The actual packet size is eight bytes larger than the specified size specified because the device adds header information. (Range: 56 - 1472 bytes) • packet_count - Number of packets to send. If 0 is entered, it pings until stopped. (Range: 0-65535 packets) • time_out - Timeout in milliseconds to wait for each reply. (Range: 50 - 65535 milliseconds) Default Configuration Default packet size is 56 bytes. Default number of packets to send is 4. Default timeout value is 2000 milliseconds. Command Mode User EXEC mode User Guidelines Press Esc to stop pinging. Following are examples of unsuccessful pinging: Destination does not respond. If the host does not respond, a "no answer from host" appears in ten seconds. Destination unreachable. The gateway for this destination indicates that the destination is unreachable. Network or host unreachable. The device found no corresponding entry in the route table. Page 264