Thermador KBUDT4865E Installation Instructions - Page 12

To minimize panel weight, you may use 2" (5.08 cm) spacer strips around the perimeter in place of full-sheet solid spacer panels. The spacer strips must be set in at least 1" (2.54 cm) from the top, bottom and sides edges of the backer panel. If you use spacer strips, it is also recommended that you use two 2" (5.08 cm) strips horizontally centered for added support. Freezer Framed Dispenser A Freezer Frameless Dispenser A 81/2" (21.59 cm) Top Grille C 73/8" (18.73 cm) F Freezer Non-Dispenser A Refrigerator B Bottom Offset 1" (2.54 cm) 23 59.53 cm) D Handle-Side Offset ¹⁄₈" (3.2 mm) 24" (60.96 cm) 23 59.53 cm) D Handle-Side Offset ¹⁄₈" (3.2 mm) Handle-Side Offset ¹⁄₈" (3.2 mm) 47 119.86 cm) 12 31.27 cm) D 34³⁄₈" (87.3 cm) 71 180.50 cm) Bottom Offset ¹⁄₈" (3.2 mm) A 70¹⁄₂" (179.07 cm) D D 34³⁄₄" (88.27 cm) 34³⁄₈" (87.3 cm) Handle-Side Offset ¹⁄₈" (3.2 mm) 71 180.50 cm) 70¹⁄₂" (179.07 cm) E Bottom Offset ¹⁄₈" (3.2 mm) Bottom Offset ¹⁄₈" (3.2 mm) Decorative Overlay Panels Model A B C 42" (106 cm) 17 ¹⁄₈" (43.50 cm) 23 ¹⁄₈" (58.74 cm) 41 ³⁄₈" (105.09 cm) 48" (122 cm) 19 49.85 cm) 26 67.63 cm) 47 ³⁄₈" (120.33 cm) Bottom Offset ¹⁄₈" (3.2 mm) Bottom Offset ¹⁄₈" (3.2 mm) Backer Panels Model D E F 42" (106 cm) 16 22 40 ¹⁄₂" (102.87 (43.50 cm) (58.26 cm) cm) 48" (122 cm) 19 49.37 26 67.15 46 ¹⁄₂" (118.11 cm) cm) cm) Stainless Steel Series Side Panels Custom side panels may be needed when not enough space is available to have cabinets on both sides of the refrigerator or when the refrigerator is placed at the end of a cabinet run. You may choose an Inset, Flush, or Recessed Inset panel installation. s If the opening depth is 25" (63.5 cm) or more, you may want to install a support board on rear wall. Refrigerator Refrigerator and Side Trim Dimensions The width and height of a side panel are determined by the type of installation you are planning. NOTES: s The dimensions shown are actual product dimensions and may not reflect the needed panel installation dimensions. s The side panel should be a minimum of ½" (1.27 cm) thick to avoid warping. 24¹⁄₈" (61.3 cm) 23 60.3 cm) 23¹⁄₂" (59.7 cm) 12