Thermador KBUDT4865E Installation Instructions - Page 21
Level Refrigerator, Adjust Doors
View all Thermador KBUDT4865E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
5. Replace the top grille in the cabinet side trims and pull the panel down slightly to lock it into place. B A B Adjust Doors Door Height Adjustment Use the following steps to adjust the door height, up or down, after the doors have been leveled. 1. Open the freezer or refrigerator door. Remove the door stop screw from the bottom side of the bottom hinge. A. Top grille B. Cabinet side trim Level Refrigerator NOTE: Custom or full-overlay door panels must be installed before leveling the refrigerator. 1. Open the doors and place the level on top of the refrigerator frame as shown. Check to see whether the refrigerator is level from left to right. A A BC A. Bushing B. Door stop screw C. Locking plate 2. Remove the locking plate as shown. B B A. Level to check left to right leveling B. Level to check front to back leveling 2. Use the leveling bolts to adjust the leveling legs until the refrigerator is level from left to right. A A B B A. Rear leveling bolt B. Front level bolt 3. Place the level(s) on shelf or shelves. Check to see whether the refrigerator is level from front to back. 4. Use the leveling bolts to adjust the leveling legs until the refrigerator is level from front to back. 5. Be sure that all four leveling legs contact the floor and support the full weight of the refrigerator. 6. Make final check to ensure the refrigerator is level. 3. Turn the bushing located underneath the bottom of the hinge using the open-end wrench. Turning the bushing to the left (counterclockwise) will raise the door. Turning the bushing right (clockwise) will lower the door. 4. After adjusting, check the doors to make sure they are even at the top and bottom. If the doors are not even, continue to turn the bushing to adjust the door height. 5. Replace the locking plate. 6. Turn the bushing slightly to align the hinge and locking plate screw holes. 7. Replace the door stop screw or screws and tighten. 8. Recheck to make sure the doors are aligned and even. 21