Thermador KBUDT4865E Installation Instructions - Page 22
Install Side Panel, Install Base Grille
View all Thermador KBUDT4865E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Door Swing Adjustment 1. Check that the refrigerator door can open freely. If the door opens too wide or you are installing full-overlay custom panels using a Trimless Trim Kit, you should adjust the door swing. 2. Remove the door stop screw or screws (depending on your model) from the bottom hinge. See "Door Height Adjustment" earlier in this section. 3. Hold the door open to a position that is less than 90°. 4. Replace the door stop screw or screws in the bottom hinge and tighten. NOTE: If you are using full-overlay custom panels with the Trimless Trim Kit, the door stop should be replaced in either the 90° or 110° position. See "Handle and Door Clearances for Custom Panel Series." Install Side Panel If the built-in area depth is 25" (63.5 cm) or more, the side panels can be installed inside the side trim or attached to the outside of the side trim. IMPORTANT: Thermador is not responsible for the removal or addition of molding or decorative panels that would not allow access to the refrigerator for service. 1. For the inside side trim piece, slide the front edge of the routed side panel into the trim piece. 2. Nail the rear edge of the panel to the support board. A AB C A. 130° B. 110° C. 90° 22 B A. Support board B. Side trim piece Install Base Grille There are two pieces to the base grille to allow for a custom fit: the base grille itself and the skirt. The skirt can be added to the base grille in order to extend it all the way to the floor. 1. Open the refrigerator door and measure the distance from the bottom of the refrigerator cabinet to the floor. B A C A. Floor B. Refrigerator cabinet bottom C. Distance to be measured