Thermador KBUDT4865E Installation Instructions - Page 20
Lower Leveling Legs, Install Custom Panels
View all Thermador KBUDT4865E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Lower Leveling Legs NOTE: All four leveling legs must contact the floor to support and stabilize the full weight of refrigerator. Rollers are for moving refrigerator and not for permanent support. Use a socket wrench to turn the leveling bolts clockwise to lower the 4 leveling legs until refrigerator weight is supported by leveling legs. The rollers should be off the floor. To avoid cabinet damage, do not apply more than 50 inch-pounds (58 cm - kg) of torque to the leveling legs. 5. Replace the door handles. Be sure that the top of both door handles are aligned. 6. Remove the protective skin from the screw covers. Snap the screw covers into the handle trim section. A AB B A. Rear leveling legs B. Front leveling legs Install Custom Panels IMPORTANT: Thermador is not responsible for the removal or addition of molding or decorative panels that would not allow access to the refrigerator for service. NOTE: To install full-overlay custom panels, refer to the installation instructions included with the Trimless Trim Kit. See "Design Specifications." Door Panels 1. Remove all tape and door bracing from the refrigerator and freezer doors. 2. Remove the screws that attach the handles to the door frame. 3. Slide the decorative door panels into the door frames. 4. If needed, route the door panels or install a filler panel between the doors and the decorative panels. See "Custom Panels." Top Grille Panel 1. Grasp both ends of the top grille. 2. Push straight up, then pull straight out. Place the top grille panel-side down on a soft working surface. B A B A. Top grille B. Cabinet side trim 3. Remove one end cap by loosening the nuts and sliding off the end cap. A C B D A. Bottom rail B. Nuts C. End cap D. Top rail 4. Slide the custom panel into the top grille channel and reattach the end cap. A A A. Panels 20 A A. Panel