Thermador T36BB110SS View Kitchen Design and Planning Guide - Page 114

| THERMADOR | FREEDOM® REFRIGERATION | THERMADOR | FREEDOM® REFRIGERATION PLANNING INFORMATION Under-Counter Refrigeration Model Options The Under-counter Freedom® Refrigeration Collection includes a glass door refrigerator, a glass door wine reserve, a double refrigerator drawer unit and a double refrigerator / freezer drawer unit. Glass door models are available in right-hinged and left-hinged options. All units install fully flush to be seamlessly integrated into 24" depth cabinetry. Each unit is available custom-panel ready or in stainless steel with a Masterpiece® or Professional Handle to complement the entire collection of Thermador appliances. Installation Considerations Location The appliance should be installed in a dry, ventilated room. It may not be installed outdoors. The ambient temperature of the room should stay between 55°F (13°C) and 110°F (43°C). The appliance should not be exposed to excessive heat. If installation next to a heat source, such as an oven, radiator, etc. is unavoidable, observe the following minimum distances from the heat source: • 1" (25 mm) from another refrigerator or wine reserve, • 1 1/4" (30 mm) from an electric cooking appliance, • 11 13/16" (300 mm) from an oil or solid-fuel cooking appliance. Ensure that the exterior air vent is not blocked by cabinetry or other elements. Electrical Specifications The appliance comes with a 3-wire power supply cord (NEMA 5-15p), UL-listed in the USA and requires a 3-wire receptacle that is fitted with a 15- or 20-Amp fuse. Grounding Instruction This appliance must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for the electric current. Additional Grounding Procedure Some local regulations may require a separate ground. In such cases, the required accessory ground wire, clamp and screw must be purchased separately. Never ground the appliance to plastic plumbing lines, gas lines or water pipes. A 4-conductor cord shall be used when the appliance is installed in an area where local codes do not permit grounding through the neutral. Power supply cord must be replaced by a licensed electrician only. Warning Improper connection of the equipment grounding conductor may result in electric shock. Have the appliance checked by a qualified electrician or service technician if you are in doubt as to whether the appliance has been properly grounded. Electrical Location The receptacle must be near the appliance: 61" (1550 mm) to the right of the appliance or 37" (940 mm) to the left of the appliance, and also freely accessible following installation of the appliance for future service. Water Supply Units with an icemaker require a connection to a water supply. The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 30 and 120 psi (207 and 827 kPa). If a reverse osmosis water filtration system is connected to your cold water supply the water pressure to the reverse osmosis system needs to be a minimum of 40 to 60 psi (276 to 414 kPa). Refer to the Installation Guide for details if the water pressure is less. 224 Visit Thermador.com for complete specifications or text a Thermador model number to 21432 to have specs sent to your phone INSTALLATION Under-Counter Refrigeration Glass Door Refrigerator and Glass Door Wine Reserve Product Dimensions 237/8" (607 mm) 305/8" (778 mm) 235/8" 215/8" (600 mm) (550 mm) Masterpiece 2513/16" (656 mm) Professional 261/4" (667 mm) 237/8" (607 mm) 343/8" (874 mm) 33/4" (96 mm) 343/8" (874 mm) 305/8" (778 mm) 221/4" (566 mm) Note: With the legs fully retracted the appliance has a minimum dimension of 343/8" from top to bottom. The legs can be extended up to 1/2". 31/4" (83 mm) 1/2" (13 mm) measurements in inches (mm) Cutout Dimensions 237/8" (607 mm) unit 235/8" (600 mm) unit min. 24" (min. 610 mm) counter Professional 25/8" (67 mm) Masterpiece 23/16" (56 mm) 17/8" (48 mm) 24" (610 mm) Cabinet opening measurements in inches (mm) Front view 341/2"-351/4" (877-896 mm) Counter 24 " (610 mm) Cabinet opening measurements in inches (mm) Cutout Dimensions & Electrical Location 24" (610 mm) 1" 24" (25.4 mm) (610 mm) 341/2" (877 mm) A A 4" (102 mm) A: Recommended area for installation connection - a 21/2" (63 mm) diameter hole is recommended. Location of power cord at base of the appliance. 51/8" (130 mm) A A 4" (102 mm) For flush installation, recommend outlet to be placed to the side of the unit and not directly behind. measurements in inches (mm) Visit Thermador.com for complete specifications or text a Thermador model number to 21432 to have specs sent to your phone 225