Toshiba Tecra M2-S410 Maintenance Manual - Page 267
RGB harness holder/RGB board/Modem jack
View all Toshiba Tecra M2-S410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 267 highlights
4.18 RGB harness holder/RGB board/Modem jack 4 Replacement Procedures 4.18 RGB harness holder/RGB board/Modem jack Removing the RGB harness holder/RGB board/Modem jack To remove the RGB harness holder/RGB board/modem jack, follow the steps below and refer to figure 4-34 to 4-36. 1. Remove the following screw securing the RGB harness holder. • M2.5×4B FLAT HEAD screw ×1 2. Take out the RGB harness holder while unhooking the front latches. M2.5×4B FLAT HEAD RGB harness holder Figure 4-34 Removing the RGB harness holder TECRA M2 Maintenance Manual (960-468) 4-53
4.18
RGB harness holder/RGB board/Modem jack
4 Replacement Procedures
4.18 RGB harness holder/RGB board/Modem jack
Removing the RGB harness holder/RGB board/Modem jack
To remove the RGB harness holder/RGB board/modem jack, follow the steps below and
refer to figure 4-34 to 4-36.
1.
Remove the following
screw
securing the RGB harness holder.
•
M2.5
×
4B
FLAT HEAD screw
×
1
2.
Take out the
RGB harness holder
while unhooking the front latches.
M2.5
×
4B FLAT HEAD
RGB harness holder
Figure 4-34
Removing the RGB harness holder
TECRA M2 Maintenance Manual (960-468)
4-53