Toshiba Tecra M2-S410 Maintenance Manual - Page 277
System board/DC-IN jack, Removing the System board/DC-IN jack
View all Toshiba Tecra M2-S410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 277 highlights
4.21 System board/DC-IN jack 4 Replacement Procedures 4 Replacement Procedures 4.21 System board/DC-IN jack Removing the System board/DC-IN jack To remove the system board/DC-IN jack, follow the steps below and refer to figures 4-43. 1. Remove the following screws securing the system board. • M2.5×4B FLAT HEAD screw ×1 2. Lift up the system board and DC-IN jack. 3. Disconnect the DC-IN jack cable from the connector PJ8800 on the system board. M2.5×4B FLAT HEAD DC-IN jack PJ8800 System board Figure 4-43 Removing the system board/DC-IN jack Installing the System board/DC-IN jack To install the system board/DC-IN jack, follow the steps below and refer to figures 4-43. 1. Connect the DC-IN jack cable to the connector PJ8800 on the system board. 2. Install the system board from the left side and secure it with the following screws. • M2.5×4B FLAT HEAD screw ×1 3. Install the DC-IN jack into the slot. TECRA M2 Maintenance Manual (960-468) 4-63