Toshiba Tecra M2-S410 Maintenance Manual - Page 301
Fluorescent Lamp
View all Toshiba Tecra M2-S410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 301 highlights
4.27 Fluorescent Lamp 4 Replacement Procedure 4 4.27 Fluorescent Lamp This system uses LCD modules from the following suppliers. The procedure for replacing the fluorescent lamp is different for each LCD module. Refer to the appropriate procedure. Type 14.1-inch (XGA) Part No. G33C0001P110 14.1-inch (SXGA+) VF2074P01 Supplier Samsung Sharp Section 4.27.1 4.27.2 NOTE: - When working with a LCD module, always use a flat, grounded table. - Handle the backlight unit in the environment without dust, such as on the clean bench. Keep the worktable free from any screws or other material that may scratch the LCD surface. - Use an anti-static or protective sheet. - When replacing the FL unit, cover with a finger protector or similar to prevent soiling or scratching the LCD panel. - Be careful when handling the lamp. Excessive force may break the lamp. - Be careful not to soil or deform the lamp reflector. - Make sure that the power of the LCD module is turned off before connecting or disconnecting cables and connectors. TECRA M2 Maintenance Manual (960-468) 4-87