Toshiba Tecra M5 Maintenance Manual - Page 297

4.24 LCD unit/FL inverter 4 Replacement Procedures 4.24 LCD unit/FL inverter Removing the LCD unit/FL inverter To remove the LCD unit/FL inverter, follow the steps below and refer to Figure 4-43 to 4-46. 1. Remove the keyboard holder. (Refer to Figure 4-12 on page 4-22.) 2. Remove the mask seals (2 points), mask rubbers (2 points) and following screws securing the LCD mask. • M2.5×6B FLAT HEAD screw ×2 • M2×4B S- THIN HEAD screw ×2 Mask rubber M2×4B S-THIN HEAD Mask seal Mask rubber Mask seal LCD mask M2.5×6B FLAT HEAD Figure 4-43 Removing the mask seal, mask lubber and screw 3. Remove the LCD mask (stuck with a double-sided tape) while releasing the latches. 4. Peel the insulator on the connector of HV cable and disconnect the FL cable and HV cable from the FL inverter. TECRA M5 Maintenance Manual (960-542) [CONFIDENTIAL] 4-61