Toshiba Tecra M5 Maintenance Manual - Page 301

4.24 LCD unit/FL inverter 4 Replacement Procedures Installing the LCD unit / FL inverter To install the LCD unit / FL inverter, follow the steps below and refer to Figure 4-43 to 4-46. 1. Set two LCD supports to the LCD and secure them with the following screws. • M2×3S S-THIN HEAD screw ×4 CAUTION: When installing the LCD support, do not mistake the left for the right and vice versa. "L" for the left, "R" for the right and "UP" for the up of the bracket are marked on the bracket. 2. Stand the LCD unit on the display cover and connect the LCD cable to the connector on the back of the LCD unit. Stick the glass tape on the LCD connector. 3. Install the LCD unit to the display cover. 4. Connect the FL cable and the HV cable to the FL inverter. 5. Install the FL inverter in place while sticking to the double-sided tape. 6. Stick the insulator on the connector of HV cable. 7. Install the LCD mask (with double-sided tape) while hooking the latches. 8. Secure the LCD mask with the following screws. • M2.5×6B • M2×4B FLAT HEAD screw ×2 S-THIN HEAD screw ×2 9. Stick the mask seals (2 points) and mask rubbers (2 points). TECRA M5 Maintenance Manual (960-542) [CONFIDENTIAL] 4-65