Toshiba Tecra M5 Maintenance Manual - Page 304

4 Replacement Procedures 4.26 Finger print sensor board 4.26 Finger print sensor board Removing the Finger print sensor board To remove the finger print sensor board, follow the steps below and refer to Figure 4-48. 1. Remove the speaker cable from the guides. 2. Peel off the glass tape on the finger print sensor cable. 3. Lift up the tip of bracket while releasing the latch and remove it. 4. Lift up the tip of finger print sensor board while releasing the latch and slide it to remove. 5. Disconnect the finger print sensor cable from the connector on the finger print sensor board. Bracket Bracket Glass tape Finger print sensor cable Latch Finger print sensor board Speaker cable Bracket Figure 4-48 Removing the finger print sensor board 4-68 [CONFIDENTIAL] TECRA M5 Maintenance Manual (960-542)