Vtech DS6472-6 User Manual - Page 115
I cannot dial out.
View all Vtech DS6472-6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
Appendix Troubleshooting • Test a working telephone at the telephone wall jack. If another telephone has the same problem, the problem is in the telephone wall jack. Contact your telephone service provider (charges may apply). • The telephone line cord may be defective. Install a new telephone line cord. • Remove and install the battery again and then place the handset in the telephone base or charger. • Wait for the handset to synchronize with the telephone base. Allow up to one minute for this to take place. I cannot dial out. • Try all the above suggestions. • Make sure there is a dial tone before dialing. It is normal if the handset takes a second or two to synchronize with the telephone before producing a dial tone. Wait an extra second before dialing. • If other telephones in your home are having the same problem, the problem is in the wiring or telephone service. Contact your telephone service provider (charges may apply). • Eliminate any background noise. Mute the cordless handset before dialing, or dial from another room in your home with less background noise. My handset beeps and is not performing normally. • Make sure the power cord is securely plugged into the telephone base. Plug the telephone base into a different working electrical outlet not controlled by a wall switch. • Move the handset closer to the telephone base. It may be out of range. • Reset the telephone base by unplugging the electrical power to the base. Wait for 15 seconds and plug it back in again. Allow up to one minute for the cordless handset and the telephone base to synchronize. • Other electronic products such as HAM radios and other DECT phones can cause interference with your cordless phone. Try installing your phone as far away as possible from these types of electronic devices. There is interference during a telephone conversation. My calls fade out when I am using the cordless handset/headset. • The handset or headset may be out of range. Move it closer to the telephone base. • If you subscribe to high-speed Internet service (DSL - digital subscriber line) through your telephone line, you must install a DSL filter between the telephone line cord and the telephone wall jack. The filter prevents noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters. • Appliances or other cordless telephones plugged into the same circuit as the telephone base can cause interference. Try moving the appliance or telephone base to another outlet. 110