Yamaha A5000 Owner's Manual - Page 141

EDIT-EG Knob 4 [ Turn] PEG Decay Rate This value sets the rate at which the pitch moves from the attack level to the sustain level. Higher values produce faster rates. [Range] 0 - 127 [ Press] QUICK... Calls the quick entry menu (page 83). Knob 5 [ Turn] PEG Release Rate This value sets the rate at which the pitch moves from the sustain level to the release level following Note Off. Higher values produce faster rates. [Range] 0 - 127 • Note that the effectiveness of this setting declines at higher AEG release rates (page 137), since the sound dies out before the shift in pitch can be heard. [ Press] QUICK... Calls the quick entry menu (page 83). Cursor w (Pitch EG Level) Cursor w Turn action Press action Knob 1 Cursor/Page Tree View Knob 2 PEG Initial Level QUICK... Knob 3 PEG Attack Level QUICK... Knob 4 Knob 5 PEG Sustain PEG Release Level Level QUICK... QUICK... • If all levels are set to maximum (+127 or -127), the actual amount of pitch variation range is determined by the PEG Range setting (page 142). Knob 1 Same function as Cursor q (page 140). Knob 2 [ Turn] PEG Initial Level This value sets the initial level (the pitch offset applied at time of Note On). [Range] -127 - +127 [ Press] QUICK... Calls the quick entry menu (page 83). Knob 3 [ Turn] PEG Attack Level This value sets the attack level. (See illustration, page 140) [Range] -127 - +127 [ Press] QUICK... Calls the quick entry menu (page 83). Knob 4 [ Turn] PEG Sustain Level This value sets the sustain level. (See illustration, page 140) [Range] -127 - +127 [ Press] QUICK... Calls the quick entry menu (page 83). Knob 5 [ Turn] PEG Release Level This value sets the release level. (See illustration, page 140) [Range] -127 - +127 [ Press] QUICK... Calls the quick entry menu (page 83). Cursor e (Pitch EG Mode) Cursor e Turn action Press action Knob 1 Cursor/Page Tree View Knob 2 PEG Rate Scaling QUICK... Knob 3 PEG Rate Velocity Sensitivity QUICK... Knob 4 PEG Level Velocity Sensitivity QUICK... Knob 5 PEG Range QUICK... Knob 1 Same function as Cursor q (page 140). Knob 2 [ Turn] PEG Rate Scaling This setting determines how the PEG rates (PEG attack, PEG decay, and PEG release rates) vary according to keyboard location (pitch) of the played note. Set the value to 0 to keep rates the same for all keyboard notes. Positive settings cause rates to increase as you move up the keyboard, while negative settings cause rates to decrease as you move up the keyboard. [Range] -7 - +7 [ Press] QUICK... Calls the quick entry menu (page 83). Knob 3 [ Turn] PEG Rate Velocity Sensitivity This value sets the velocity sensitivity for the PEG rates: the amount by these PEG rates (PEG attack, PEG decay, and PEG release rates) vary in response to the velocity (force) of the played note. Set the value to 0 to keep rates the same for all velocities. Positive settings cause rates to increase as velocity increases, while negative settings cause rates to decrease as velocity increases. [Range] -63 - +63 141 q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q A5000/A4000 • Chapter 5 EDIT Mode