Yamaha A5000 Owner's Manual - Page 246
for Installing an Internal SCSI Hard Disk., The IDE hard disk is now fully installed.
View all Yamaha A5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 246 highlights
Installing Optional Equipment 8. Connect the hard disk power cable (long) to one of the power connectors in the A5000/ A4000. • Connect the hard disk power cable to any of the available power connectors- CN1, CN2, or CN4. • If no expansion board or ZIP drive is installed, all three connectors will be available. Any of these con- nectors can be used. • If at any time you need to disconnect any of these connectors, do so while pressing the release clip on the plug. Do not apply excessive force. 9. Install the hard disk and mount panel assembly in the A5000/A4000. Refer to page 243 for "Installing an Internal SCSI Hard Disk." 10. Secure the cables with the cable straps. • Secure the connected flat cable and power cable with the cable straps as shown in the illustration. • Damage can result if the loose end of the cable is allowed to come in contact with other internal circuitry. Be sure to secure the loose end of the cable with the cable strap. The IDE hard disk is now fully installed. There is no need to remove the disk when installing other devices. 11. Replace the top cover (page 233). 12. Plug in the power cord. Important • After installing the hard disk, connect your audio and MIDI devices, and turn on the A5000/A4000. Then mount the hard disk (page 173), format it (page 177), and partition it into volumes (page 172). 246 Appendix • A5000/A4000 q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q