Yamaha CDR HD1500 MCXSP10 Manual - Page 83
Appendix, Symptom, Cause, Remedy - replacement
UPC - 027108922737
View all Yamaha CDR HD1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
TROUBLESHOOTING SYMPTOM CAUSE REMEDY This unit does not operate properly. The internal microcomputer has been frozen. Turn off the power of this unit and then turn on again after about one minute (P.14). There is rotation noise of the fan. The temperature inside this unit rises. The fan starts to rotate to cool off the temperature inside this unit. A noise occurs at the change of the tracks that has been recorded from the analog record and edited. A very low frequency component among the wow and flutter of the analog record is being output as a noise. Improvement can be made by adding a short fade-in or fade-out to the track (P.64). Remote control does not work. The batteries of the remote control are too weak. Replace two batteries with new ones (P.11). Remote control is from too far. Remote control is being used at an incorrect angle. Use the remote control within 6 m and 60 degrees radius (P.11). Direct sunlight or lighting (of an inverter type Change the position so that the remote control sensor is not of fluorescent lamp, etc.) is striking the exposed to strong lighting. remote control sensor. TV does not correctly function when the remote control is being used. Remote control is being used near TV set with a remote control sensor. Relocate this unit away from the TV or cover the TV's remote control sensor. The picture on the TV is impaired. The indoor antenna is used. Use an outdoor antenna, or set this unit away from the TV set. 7 APPENDIX English 77