Yamaha CRX-M5 Owner's Manual - Page 12

GETTING STARTED Connecting the external antennas To improve the reception, connect the external antennas instead of the supplied antennas. AM antenna Use a 6 to 15 meter (20 to 50 feet) insulated wire to connect to the AM antenna terminal and leave the supplied AM loop antenna connected. Insulated wire (not supplied) Ground wire (not supplied) GND AM Important When connecting an outdoor antenna, be sure to connect a ground wire also to protect against lightning. Be careful not to connect the ground wire to a gas pipe to prevent a gas explosion. FM antenna Connect the external antenna. FM 75 UNBAL 75-ohm coaxial cable (not supplied) To enjoy synchro play or timer play You can enjoy synchro recording (see page 23) or the timer function (see page 18) by connecting the MDXM5 or KX-M5 to the system with the system cable. For details, refer to the instructions supplied with the MDXM5 or KX-M5. Preparing the remote control transmitter Loading the batteries for the remote control transmitter 1 Remove the battery compartment cover. 2 Insert 2 AAA size batteries into the battery compartment. - + + - 3 Replace the battery compartment cover. Battery replacement If you find that the remote control transmitter must be used closer to the main unit than usual, the batteries are weak. Replace both batteries with new ones. Notes • Use only AAA batteries for replacement. • Be sure the polarities are correct. (See the illustration inside the battery compartment.) • Remove the batteries if the remote control transmitter will not be used for an extended period of time. • If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries. E-6