Yamaha CRX-M5 Owner's Manual - Page 32
CD preventive care, Troubleshooting
View all Yamaha CRX-M5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
ADDITIONAL INFORMATION CD preventive care • This compact disc player is designed for playing compact discs bearing the mark only. Never attempt to load any other type of disc into the unit. The unit will also play 8-cm (3-inch) compact discs. • Compact discs are not subjected to wear during play, but damage to the disc surface when the disc is being handled can adversely affect the disc's play. • Do not use cleaning discs or warped discs. All of these could damage the unit. • Compact discs are not affected by small particles of dust or fingerprints on their playing surface, but even so they should be kept clean. Wipe by using a clean, dry cloth. Do not wipe with a circular motion; wipe straight outward from the center. To prevent a malfunction of this unit • Do not use any non standard shaped CD (heart etc.) available on the market, because it may damage the unit. • Do not use a CD with tape, seals, or paste on it, because damage to the unit may result. • Do not try to clean the disc's surface by using any type of disc cleaner, record spray, anti-static spray or liquid, or any other chemical-based liquid, because such substances might irreparably damage the disc's surface. • Do not expose discs to direct sunlight, high temperature or high humidity for a long period of time, because these might warp or otherwise damage the disc. No! Troubleshooting If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power cord and contact your authorized YAMAHA dealer or service center for help. When taking the service, the MDX-M5 or KX-M5 may be needed. For details, contact your authorized YAMAHA dealer or service center. SYMPTOM The player does not switch ON when the STANDBY/ON switch is pressed. No sound from one speaker. No sound from speakers. CAUSE The AC power cord is not connected or not completely connected. Loose speaker connections. Internal protection circuit is functioning. SYSTEM/TUNER No sound from an external unit connected with this unit or play does not begin. E-26 Incorrect cord connections. Input source selection is not proper. REMEDY Securely connect the power cord. Connect properly. Unplug the AC power cord from the wall outlet, and then plug in again. Connect the cords properly. If the problem persists, the cords may be defective. Make a proper input source selection.