Yamaha HTR 5890 MCXSP10 Manual - Page 63

ADVANCED OPERATION p ■ Low frequency test G)LOW FRQ. TEST Use this feature to adjust the output level of the subwoofer so it matches your other speakers. G)LOW FRQ.TEST . TEST TONE;;;;OFF OUTPUT;FRONT L/R FRQ;;;;;;;;;88Hz SET MENU ■ Headphone tone control H)HP TONE CTRL Use to adjust the amount of bass and treble output to your headphones. Choices: -6 to +6 (dB) H)HP TONE CTRL . BASS TRBL - + 0dB / : Up/Down : Adjust 1 Press l / h to set TEST TONE to ON, and adjust the volume with VOL -/+ so you can hear the tone. Do not turn up the volume too high. If no test tone is heard, turn down the volume, set this unit in the standby mode and make sure all the necessary connections are correct. The tone generator produces a narrow-band noise centered on a specified frequency by the band pass filter, as well as a wide-band noise. 2 Press n to go to OUTPUT and press l / h to select the speaker you want to compare with the subwoofer. Choices: FRONT L/R, FRONT L, CENTER, FRONT R, SUR.R, SBR*, SBL*, SUR.L, SWFR, PRESENCE * "SB" will be displayed if you selected only one surround back speaker in SURR B L/R SP (page 56). 3 Press n to go to FRQ and press l / h to select the frequency you want to use. Choices: 35 to 250 (Hz), WIDE Initial: 88 Hz 4 Adjust the volume of the subwoofer with the controls on the subwoofer so it matches that of the speaker you are comparing it to. y You can use the test tone not only for adjusting the subwoofer level, but also for checking the low-frequency characteristics of your listening room. Low-frequency sounds are especially affected by the listener's position, speaker placement, subwoofer polarity and other conditions. p • Use BASS to adjust the headphone bass level. • Use TRBL to adjust the headphone treble level. ■ Audio set I)AUDIO SET Use to customize this unit's overall audio settings. I)AUDIO SET . AUDIO MUTE;;MUTE AUDIO DELAY;;0ms DIALG.LIFT;;;OFF / : Exit : Select Mute MUTE Use to adjust how much the mute function reduces the output volume. Choices: MUTE, -20 dB • Select "MUTE" to completely halt all output of sound. • Select "-20 dB" to reduce the current volume by 20 dB. Audio Delay AUDIO DELAY Use to delay the sound output and synchronize it with the video image. This may be necessary when using certain LCD monitors or projectors. Choices: 0 to 240 (ms) Dialog lift DIALG.LIFT Use to turn on/off the DIALG.LIFT parameter (see page 85). This parameter adjusts the height of the front and center channel sounds (dialog, vocals, etc.) by assigning some of the front and center channel elements to the presence speakers. Choices: ON, OFF • Select "ON" to turn on DIALG.LIFT effect. • Select "OFF" to turn off DIALG.LIFT effect. Note DIALG.LIFT appears only when PRESENCE is set to "YES" (see page 31). 59