Yamaha HTR 5890 MCXSP10 Manual - Page 93
Tuner, good FM antenna.
UPC - 027108922133
View all Yamaha HTR 5890 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
TROUBLESHOOTING Problem Cause Remedy There is noise interference from digital or radiofrequency equipment, or this unit. This unit is too close to the digital or radio-frequency equipment. Move this unit further away from such equipment. The picture is disturbed. The video source uses scrambled or encoded signals to prevent dubbing. There is noise when the OSD is displayed. The OSD may be disturbed when displaying OSD through component video connections. Select OFF in CMPNT OSD. This unit suddenly turns into the standby mode. The internal temperature becomes too high and the overheat protection circuitry has been activated. Wait for about 1 hour until this unit cools down and then turn it back on. Refer to page - 63 - ■ Tuner Problem FM stereo reception is noisy. There is distortion, and clear reception cannot be obtained even with a FM good FM antenna. The desired station cannot be tuned in with the automatic tuning method. Previously preset stations can no longer be tuned in. The desired station cannot be tuned in with the automatic tuning method. AM There are continuous crackling and hissing noises. There are buzzing and whining noises. Cause The characteristics of FM stereo broadcasts may cause this problem when the transmitter is too far away or the antenna input is poor. There is multipath interference. The signal is too weak. This unit has been disconnected for a long period. The signal is weak or the antenna connections are loose. Noises result from lightning, fluorescent lamps, motors, thermostats and other electrical equipment. A TV set is being used nearby. Remedy Check the antenna connections. Try using a high-quality directional FM antenna. Use the manual tuning method. Adjust the antenna position to eliminate multipath interference. Use a high-quality directional FM antenna. Use the manual tuning method. Preset the stations again. Tighten the AM loop antenna connections and orient it for best reception. Use the manual tuning method. Use an outdoor antenna and a ground wire. This will help somewhat, but it is difficult to eliminate all noise. Move this unit away from the TV. Refer to page 23 41 - 23 41 42 - 41 - - ADDITIONAL INFORMATION 89