Yamaha QL1 Reference Manual - Page 190
Switching the entire phantom power supply on/ off, Specifying the brightness of the touch screen, LEDs
View all Yamaha QL1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 190 highlights
4 PAN LINK button This button appears if SIGNAL TYPE is set to STEREO and the bus type is set to VARI. If the button is on, the pan setting of signals sent from input channels to the corresponding two buses will link with the STEREO bus pan setting. 5 Tabs Enable you to switch between the MIX and MATRIX buses. Switching the entire phantom power supply on/ off STEP 1. In the Function Access Area, press the SETUP button to access the SETUP screen. 2. In the center of the SETUP screen, press the +48V MASTER field's ON button or OFF button. If this button is off, phantom power will not be supplied even if the +48V button of an OMNI jack input channel or TALKBACK IN is on. Setup Specifying the brightness of the touch screen, LEDs, channel name displays, and lamps Follow the steps below to specify the brightness of the touch screen, top panel LEDs, channel name displays, and lamps connected to the rear panel LAMP connectors. You can save two different brightness settings in bank A and B, and switch between them rapidly if desired. STEP 1. In the Function Access Area, press the SETUP button. 2. In the field located in the right of the bottom row of the SETUP screen, press the BANK A or BANK B button. 3. Use the [TOUCH AND TURN] knob to adjust the brightness of each item. NOTE You can also assign this parameter to a USER DEFINED key, and press that key to switch between banks A and B. SETUP screen (brightness setting field) SETUP screen NOTE This +48V MASTER setting does not affect the inputs of external racks such as DANTE inputs (I/O devices). Each rack has a +48V MASTER switch, and will operate according to its setting. 1234 56 7 1 BANK A/B buttons Switch between the brightness settings. CONTRAST field 2 NAME Adjusts the contrast of the characters of the channel name displays on the top panel. BRIGHTNESS field 3 NAME Adjusts the brightness of the channel name displays on the top panel. This will also change the CH COLOR brightness and LED brightness in the lower part of the [TOUCH AND TURN] knob. If you want to adjust the CH COLOR brightness after setting the name display brightness, use the CH COLOR knob. 4 CH COLOR Adjusts the brightness of the channel colors on the top panel. This lets you apply a relative adjustment to only the channel color brightness without changing the channel name display brightness. 190 Reference Manual