Yamaha QL1 Reference Manual - Page 202
Error messages, Warning messages, Flash x2, Blinking, Lit or
View all Yamaha QL1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 202 highlights
Error messages The SYSTEM indicators will remain lit/blinking cyclically as follows until the problem has been resolved. If service is necessary, please contact the Yamaha service center listed in the QL5/QL1 Owner's Manual. [SYSTEM] indicators Meaning Possible solution Flash x2 Flash x3 Lit Flash x3 An internal error has occurred. The MAC address setting has been corrupted and no communication can occur via Dante. The device has failed. Contact your Yamaha dealer for repair. The internal memory has been corrupted. If the problem persists after setting START UP MODE back to RESUME and turning the power on again, consult your Yamaha dealer. UNIT ID is not unique. Set a unique UNIT ID number for the Dante network. Lit Blinking The DIP switches are not set correctly. Check the DIP switch settings, and set them correctly. Lit Blinking Dante flow number limit was exceeded. Examine the Dante network routing. Warning messages The indicators will remain lit/blinking cyclically until the problem has been resolved. If the green [SYNC] indicator is not lit, the device's word clock is not defined. Setup [SYNC] indicators Meaning Possible solution Blinking The word clock is not set correctly. Set the word clock master and the sampling frequency correctly on the QL5/QL1-native device or in Dante Controller. Flash x2 Dante Network circuit is broken. Make sure that the Ethernet cables are not removed or shortcircuited. Flash x3 Dante Network is connected incorrectly. Other Dante devices cannot be found. Make sure that the Ethernet cables are connected correctly. If the green indicator is blinking, the unit is operating as the word clock master. If the green indicator lights, the unit is operating as a word clock slave and synching to the word clock. [SYNC] indicators Meaning Possible solution Lit or Lit blinking Lit or Blinking blinking A non-GbE-compatible device is connected. If audio is transmitted over the Dante network, use a GbEcompatible device. The SECONDARY connector has taken over communications during redundant network operation. Check the circuit connected to the PRIMARY connector. 202 Reference Manual