Yamaha R-V905 Owner's Manual - Page 50

SETUP CODES Presetting the remote control transmitter Perform the presetting procedure for each component you want to control with this remote control transmitter. Note: If your component does not respond to any of the codes listed for the manufacturer, use the original remote control that came with the component. To control your components (MD recorder, DVD player, TV etc.) 1. Turn on the component to be used. 2. Set the SELECTOR DIAL to the desired component (TAPE/MD, DVD/LD, TV etc.). 3. Press both VOLUME buttons ( ) at the same time until the indicator flashes twice. To use a second (and third) VCR You can use the CBL/DBS and/or DVD MENU positions to control a second VCR (and/or third) if a CBL (or DBS) or DVD player is not used. If you are using the DVD MENU position for a second (or third) VCR, you must preset a code for an LD player to the DVD/LD position. 1. Turn on the VCR to be used. 2. Set the SELECTOR DIAL to the CBL/DBS or DVD MENU position. 6. Press POWER (or any other button) on the remote control transmitter to check if you have preset the code correctly. If the VCR cannot be controlled using the remote control transmitter, try entering another code for the same manufacturer. Returning to the default code To return all components to the default code, follow these steps. 1. Press both VOLUME buttons ( ) at the same time until the indicator flashes twice. 2. Enter the code number "9987". 3. Make sure that the indicator flashes twice. 4. Use the numeric buttons to enter the four-digit manufacturer's code for the component to be used. Make sure that the indicator flashes twice. If the indicator does not flash, repeat step 3 and re-enter the code. 3. Press both VOLUME buttons ( ) at the same time until the indicator flashes twice. 4. Press MUTE. To return each component to the default code, follow these steps. 1. Set the SELECTOR DIAL to the component to be return to the default code. 2. Press both VOLUME buttons ( ) at the same time until the indicator flashes twice. 3. Enter the code number "9999". 4. Make sure that the indicator flashes twice. The following codes are preset as the default code. 5. Press POWER (or any other button) on the remote control transmitter to check if you have preset the code correctly. If the component cannot be controlled using the remote control transmitter, try entering another code for the same manufacturer. 5. Use the numeric buttons to enter the four-digit code for a second (or third) VCR. Make sure that the indicator flashes twice. If the indicator does not flash, repeat step 3 and 4, and re-enter the code. Default codes POSITION Component Code*1 Code*2 TV TV 0047 0037 CBL/DBS DBS tuner 2566 2455 VCR VCR 3060 3072 DVD/LD DVD player 4545 YAMAHA CD CD player 6187 YAMAHA TAPE/MD Tape deck 8524 YAMAHA *1: Canada and China models *2: Australia model We recommend that you write all code numbers you have preset on the "Quick Reference Card". 50