Yamaha RX-V2600 Owner's Manual - Page 109
Setting remote control codes
UPC - 027108924397
View all Yamaha RX-V2600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
REMOTE CONTROL FEATURES Setting remote control codes You can control other components by setting the appropriate remote control codes. Codes can be set up for each input area. For a complete list of available remote control codes, refer to "LIST OF REMOTE CONTROL CODES" at the end of this manual. The following table shows the default component (Library: component category) and the remote control code for each input area. Remote control code default settings Input area A XM PHONO TUNER CD MULTI CH INPUT V-AUX CBL/SAT MD/TAPE CD-R DTV VCR 1 DVR/VCR2 DVD Library (component category) TAPE TUNER TV TUNER CD Default YAMAHA code 2700 2604 - 2602 2300 DVD 2102 VCR CABLE MD CD-R TV VCR DVR DVD - - 2500 2400 - - 2807 2102 Note You may not be able to operate your YAMAHA component even if a YAMAHA remote control code is preset as listed above. In this case, try setting another YAMAHA remote control code. 1 Set AMP/SOURCE/TV to SOURCE. AMP SOURCE TV 3 Press and hold LEARN for about 3 seconds using a ballpoint pen or similar object. The library name (ex. L;DVD) and the selected component name (ex. DVD) appear alternately in the display window. LEARN y If you want to setup for another component, press the input selector button or SELECT k / n to select the component. Notes • Be sure to press and hold LEARN for at least 3 seconds, otherwise the learning process will start. • If you do not complete each of the following steps within 30 seconds, the setting mode will be automatically canceled. In this case, press LEARN again. 4 If you want to change a library (component category), press l / h. You can set a different type of component. Library choices: L;DVD, L;DVR, L;LD, L;CD, L;CDR, L;MD, L;TAP (tape), L;TUN (tuner), L;AMP, L;TV, L;CAB (cable), L;SAT (satellite), L;VCR Notes • The tuner library (L;TUN) code is preset in the TUNER and XM buttons in order to operate this unit. The initial settings for the TUNER and XM buttons are 2602 and 2604 respectively. However, you can switch the tuner library code by entering one of the following codes if necessary. • The AMP library (L;AMP) code is preset to 2001 in order to operate this unit. However, you can switch the AMP library code by entering one of the following codes if necessary. 2 Press an input selector button to select the source component you want to set up. A XM AUDIO SEL SLEEP PHONO TUNER CD MULTI CH IN V-AUX CBL/SAT MD/TAPE CD-R DTV VCR 1 DVR/VCR2 DVD ADVANCED OPERATION 105