Yamaha RX-V2600 Owner's Manual - Page 126
Problem, Cause, Remedy, No sound from - problems
UPC - 027108924397
View all Yamaha RX-V2600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
TROUBLESHOOTING Problem The sound suddenly goes off. Only the speaker on one side can be heard. Only the center speaker outputs substantial sound. No sound from the effect speakers No sound from the center speaker No sound from the surround speakers No sound from the surround back speakers No sound from the subwoofer Cause Remedy The protection circuitry has been activated because of a short circuit, etc. Check that the impedance selector setting is correct. Check the speaker wires are not touching each other and then turn this unit back on. The sleep timer has turned the unit off. Turn on the power, and play the source again. The sound is muted. Press MUTE to cancel a mute. Incorrect cable connections. Connect the cables properly. If the problem persists, the cables may be defective. Incorrect balance settings in the GUI menu. Adjust the Speaker Level settings. When playing a monaural source with a CINEMA DSP program, the source signal is directed to the center channel, and the front and surround speakers output effect sounds. The sound field programs are turned off. Press STRAIGHT (EFFECT) to turn them on. You are using a source or program combination that does not output sound from all channels. Try another sound field program. The output level of the center speaker is set to minimum. Raise the level of the center speaker. Center is set to None in Speaker Set. Select the appropriate setting for the center speaker. One of the HiFi DSP programs (except for Try another sound field program. 7ch Stereo) has been selected. The output level of the surround speakers Raise the output level of the surround speakers. is set to minimum. Surround is set to None in Speaker Set. Select the appropriate setting for the surround left and right speakers. A monaural or stereo source is being played with STRAIGHT. Press STRAIGHT (EFFECT) to turn on the sound fields. Presence speakers are selected. Select Surround Back in PR/SB Priority. Surround is set to None in Speaker Set. If the surround left and right speakers are set to None, surround back speakers are automatically set to None. Select the appropriate setting for the surround left and right speakers. Surround Back is set to None in Speaker Select Small x1, Small x2, Large x1 or Large x2. Set. Bass Out is set to Front when a Dolby Digital or DTS signal is being played. Select SWFR or Both. Bass Out is set to SWFR or Front when a Select Both. 2-channel source is being played. The source does not contain low bass signals. See page 31 - - 39 20 93 43 37 93 90 37 93 90 - 86 90 90 92 92 122