Yamaha V3.0.x M7cl V3 Editor Owner's Manual (v3.0.x) - Page 40
If a MIX channel is selected, CHANNEL SELECT Channel selection, TO MATRIX
View all Yamaha V3.0.x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
If a MIX channel is selected ❏ CHANNEL SELECT (Channel selection) 1 2 A SELECT (Channel selection) Except for the fact that your editing applies to a MIX channel, this is the same as the channel selection for an input channel (➥ p.30). 3 B LIBRARY Accesses the Output Channel Library. Click this button to open the OUTPUT CH page of the Library window. C INPUT PATCH Selects the input source assigned to the input channel (for the selectable input sources, ➥ p.22) If multiple patches have been made, only the first port is shown. If you change the patching in this window, the port that had been assigned until then will be cancelled, and only the newly selected port will be assigned. ❏ TO MATRIX A MATRIX send level 1 This adjusts the send level of the signal sent from the MIX channel to the MATRIX 2 buses. 3 B ON (MATRIX send on/off) This is an on/off switch for the signal sent from the MIX channel to the MATRIX bus. C POINT (Send point) Select either PRE or POST as the position from which the signal is sent from the MIX channel to the MATRIX bus. PRE POINT is selected if this is on, or POST FADER is selected if this is off. The PRE POINT setting can be made in the Mixer Setup dialogbox. 40 M7CL V3 Editor Owner's Manual