Yamaha V3.0.x M7cl V3 Editor Owner's Manual (v3.0.x) - Page 64

Meter window, INPUT METER

Get Yamaha V3.0.x PDF manuals and user guides View all Yamaha V3.0.x manuals
Add to My Manuals
Save this manual to your list of manuals

Page 64 highlights

Meter window This window shows the signal levels of each section in the M7CL, letting you check for the presence of signals and whether an overload is occurring. This window is divided into INPUT METER and OUTPUT METER; to switch pages, click the tabs located at the top of the window. NOTE In order to view the M7CL's signal levels in the Meter window, make sure that M7CL Editor and the M7CL itself are synchronized. INPUT METER page 1 2 3 A METERING POINT Select one of the following as the point where metering will occur. PRE HPF, PRE FADER, POST ON B PEAK HOLD Switches peak hold on/off. C Meters These peak level meters show the input level of each channel. The current fader value is shown in the box below. If clipping occurs at any one of the detection points in the channel, the ∑ segment will light. 64 M7CL V3 Editor Owner's Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
M7CL V3 Editor Owner’s Manual
64
This window shows the signal levels of each section in the M7CL, letting you check for the presence of signals and
whether an overload is occurring.
This window is divided into INPUT METER and OUTPUT METER; to switch pages, click the tabs located at the top
of the window.
In order to view the M7CL’s signal levels in the Meter window, make sure that M7CL Editor and the M7CL
itself are synchronized.
INPUT METER page
A
METERING POINT
Select one of the following as the point where metering will occur.
PRE HPF, PRE FADER, POST ON
B
PEAK HOLD
Switches peak hold on/off.
C
Meters
These peak level meters show the input level of each channel. The current fader value is shown in the box below.
If clipping occurs at any one of the detection points in the channel, the
∑
segment will light.
Meter window
NOTE
1
2
3