Yamaha V3.0.x M7cl V3 Editor Owner's Manual (v3.0.x) - Page 44
If a MATRIX channel is selected, CHANNEL SELECT Channel selection, FROM MIX, ST/MONO
View all Yamaha V3.0.x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
If a MATRIX channel is selected ❏ CHANNEL SELECT (Channel selection) Except for the fact that your editing applies to a MATRIX channel, this is the same as the channel selection for a MIX channel (➥ p.40). ❏ FROM MIX, ST/MONO A FROM MIX, ST/MONO send level These adjust the send levels of the signals sent from the VARI type MIX buses or STEREO/MONO buses to the MATRIX bus. The current value is shown in the numerical box immediately below. • PRE/POST These select either PRE or POST as the position from which the signal is sent from the MIX buses or STEREO/ MONO buses to the MATRIX bus. PRE POINT is selected if this is on, or POST FADER is selected if this is off. B ON(FROM MIX, ST/MONO send on/off) These are on/off switches for the signal sent from the MIX buses or STEREO/MONO buses to the MATRIX bus. HINT • If MIX buses and MATRIX buses are being used in stereo, the odd-numbered knob will be PAN. PAN (odd-numbered side) • If the FIXED type is selected for the MIX bus, only the ON button is valid. • The stereo/mono setting and the VARI type / FIXED type setting can be made in the Mixer Setup dialogbox. 44 M7CL V3 Editor Owner's Manual