Zenith C32V23 Operating Guide - Page 10
Hook Up a VCR
UPC - 044642003128
View all Zenith C32V23 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Hook Up a VCR Connect a VCR to your TV 1 Locate the Antenna In jack on the back of the VCR. RF Coaxial Round Wire (75 ohm) Typical 2 Connect the wire that runs from the antenna, accord- Antennas: Flat or ing to the diagram to the right. Make any other con- Round Wire nections as necessary. 3 Remove the back of the remote and put in two "AAA" Flat Wire (300 ohm) batteries. Back of Remote 300/75 ohm Adapter 4 Plug in your TV. Your TV is designed to operate on standard household current, 120-volt 60 Hertz AC. Do not plug it into an outlet controlled by a switch. Do not attempt to operate it on DC power. VCR Back VCR Back AV Panel In output switch 3 4 Out Audio Video TV Back 120 V AC 60 Hz No adapters or A/V cables are included with the TV. See your Zenith dealer to purchase any adapters or cables. Without A/V cables, most VCRs will not play videocassettes in stereo sound. ANTENNA/ CABLE 1 HD IN Y Pr RGB Pb DVD IN Y VIDEO 1 VIDEO 2 MONITOR IN IN OUTPUT S-VIDEO 1 S-VIDEO 2 Pr VIDEO VIDEO VIDEO Pb R AUDIO L R AUDIO L R AUDIO L R AUDIO L R AUDIO L Connect your VCR to the Video 1 or Video 2 set of input jacks PAGE 10 206-3767