Zenith C32V23 Operating Guide - Page 42
Programming the Remote
UPC - 044642003128
View all Zenith C32V23 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Programming the Remote Set up your remote to operate other brand name devices 1 Turn on the device you want to program. Indicator Light 2 On the chart on page 46/47, find the type of device you're programming, and then find the brand name. Write down the 3 PRG POWER 7 three-number code(s). CABLE VCR AUX TV 4 3 Press and hold PRG. It's recessed so it doesn't get pushed accidentally. Use a small, blunt object. When the indicator light turns on, you can release PRG. SURF FLASHBK MUTE CHANNEL VOLUME VOLUME 4 Push the button name with the type of device you're pro- gramming: VCR, CABLE, AUX, TV. 5 5 Using the NUMBER keypad, enter the three-number code you found on page 46/47. CHANNEL 123 4 56 7 89 6 Press ENTER to save the code. (The indicator light will flash 2 times, then turn off to indicate the code is valid.) 0 - MENU ENTER 6 7 Point the remote at the device and push POWER. It should turn off. If not, try the other codes listed and continue from step three. Note: To reset remote to factory settings, enter 9-1-1, in RATIO SIGNAL AUDIO VIDEO CC QUIT RECORD PAUSE TIMER SOURCE Step 5. REWIND PLAY STOP F FWD Programming your Zenith remote may allow you to use one remote to operate up to 4 different devices, if all modes are programmed. Once the device turns off, try the other functions. IF they do not operate, try another code. Or, see page 45. Not all devices will operate with your Zenith remote control. Mode / Product Compatibility TV VCR CATV AUX TVs VCRs Cable Boxes, All products on pp 46 - 47 DVDs Satellite Receivers Mini glossary PROGRAMMING PRG DEVICE Procedure to set up remote to operate other equipment. Programming mode button. Infra-red remote controllable electronic accessory devices. PAGE 42 206-3767