Zenith C32V23 Operating Guide - Page 44

Verify 3-Digit Code Stored in Mode Use the following method described below to find the code number stored in memory for each remote operating mode: TV, VCR, CABLE, and AUX Indicator Light 1 With a small blunt object, press and hold PRG for about three 1 seconds. When the light turns on, release PRG. 2 Press the mode button you want the 3-number code for, then press the TIMER button. The LED will blink the number of times to indicate the number of the first digit. There will be a 1 second pause during which the LED light will be off, then the LED will blink the number of times for the second digit of the code, and so on. For example: - One blink, no LED light for 1 second. - Three blinks, no LED light for 1 second. - Eight blinks. This is the example for code: 1-3-8. Note: Ten blinks indicate code number "0". Programming your Zenith remote may allow you to use one remote to work up to 4 different devices, if all modes are programmed. Not all devices will work with your Zenith remote control. Mode / Product Compatibility TV VCR CATV TVs VCRs Cable Boxes, DVDs Satellite Receivers AUX All products on pp 46 - 47 PRG POWER CABLE VCR AUX TV 2 SURF FLASHBK MUTE CHANNEL VOLUME VOLUME CHANNEL 123 4 56 7 89 0 - MENU ENTER 3 RATIO VIDEO SIGNAL AUDIO CC QUIT RECORD PAUSE TIMER SOURCE PLAY 2 REWIND F FWD STOP Mini glossary PROGRAMMING PRG DEVICE CODE Procedure to set up remote to operate other equipment. Programming mode key. Code to control infra-red remote controllable electronic devices: TVs, VCRs, Cable Boxes, etc. PAGE 44 206-3767