ZyXEL ES3500-24HP User Guide - Page 302

Chapter 39 Access Control Table 132 Management > Access Control > SNMP (continued) LABEL Set Community DESCRIPTION Enter the Set Community, which is the password for incoming Set- requests from the management station. Trap Community The Set Community string is only used by SNMP managers using SNMP version 2c or lower. Enter the Trap Community string, which is the password sent with each trap to the SNMP manager. Trap Destination Version IP Port Username The Trap Community string is only used by SNMP managers using SNMP version 2c or lower. Use this section to configure where to send SNMP traps from the Switch. Specify the version of the SNMP trap messages. Enter the IP addresses of up to four managers to send your SNMP traps to. Enter the port number upon which the manager listens for SNMP traps. Enter the username to be sent to the SNMP manager along with the SNMP v3 trap. Apply Cancel Note: This username must match an existing account on the Switch (configured in the Management > Access Control > SNMP > User screen). Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Click Cancel to begin configuring this screen afresh. 39.3.5 Configuring SNMP Trap Group Click Management > Access Control > SNMP > Trap Group to view the screen as shown. Use the Trap Group screen to specify the types of SNMP traps that should be sent to each SNMP manager. Note: Only the ES3500-24HP supports fanspeed and poe system traps. Figure 181 Management > Access Control > SNMP > Trap Group 302 ES3500 Series User's Guide