2010 Chevrolet Traverse Owner's Manual - Page 191

Infotainment System Speed Compensated Volume (SCV): The Speed Compensated Volume (SCV) feature automatically adjusts the radio volume to compensate for road and wind noise as the vehicle speeds up or slows down, so that the volume level is consistent. To activate SCV: 1. Set the radio volume. 2. Press the MENU button to display the radio setup menu. 3. Press the softkey under the AUTO VOLUM (automatic volume) tab on the radio display. 4. Press the softkey under the Speed Compensated Volume setting (OFF, Low, Med, or High) to select the level of radio volume compensation. Press the softkey located below the BACK tab on the MENU SETUP display or let the display time out after approximately 10 seconds. Each higher setting allows for more radio volume compensation at faster vehicle speeds. 7-5 3. To adjust the highlighted setting, do one of the following until the levels are obtained. . Turn f clockwise or counterclockwise. Press \ FWD, or s REV. . If a station's frequency is weak or if there is static, decrease the treble. To quickly adjust bass, midrange, or treble to the middle position, press the softkey under the BASS, MID, or TREB tab for more than two seconds. A beep sounds and the level adjusts to the middle position. To quickly adjust all tone and speaker controls to the middle position, press f for more than two seconds until a beep sounds. Setting the Tone (Bass/Midrange/Treble) BASS/MID/TREB (Bass, Midrange, or Treble): To adjust bass, midrange, or treble: 1. Press f until the tone control tabs display. 2. Continue pressing f to highlight the tab, or press the softkey under the tab.