2010 Chevrolet Traverse Owner's Manual - Page 236

7-50 Infotainment System Listing All Paired and Connected Phones 1. Press and hold b g for two seconds. The system responds with "Ready" followed by a tone. 2. Say "Bluetooth". The system responds with "Bluetooth ready" followed by a tone. 3. Say "List". The system lists all the paired Bluetooth devices. If a phone is connected to the vehicle, the system will say "Is connected" after the connected phone. Deleting a Paired Phone 1. Press and hold b g for two seconds. The system responds with "Ready" followed by a tone. 2. Say "Bluetooth". The system responds with "Bluetooth ready" followed by a tone. 3. Say "Delete". The system asks which phone to delete followed by a tone. 4. Say the name of the phone to be deleted. If the phone name is unknown, use the "List" command for a list of all paired phones. The system responds with "Would you like to delete ? Yes or No" followed by a tone. 5. Say "Yes" to delete the phone. The system responds with "OK, deleting ". Linking to a Different Phone 1. Press and hold b g for two seconds. The system responds with "Ready" followed by a tone. 2. Say "Bluetooth". The system responds with "Bluetooth ready" followed by a tone. 4. Start the Pairing process on the cell phone that will be paired to the vehicle. Reference the cell phone manufacturers user guide for information on this process. Locate the device named "General Motors" in the list on the cellular phone and follow the instructions on the cell phone to enter the four digit PIN number that was provided in Step 3. 5. The system prompts for a name for the phone. Use a name that best describes the phone. This name will be used to indicate which phone is connected. The system then confirms the name provided. 6. The system responds with " has been successfully paired" after the pairing process is complete. 7. Repeat Steps 1 through 7 for additional phones to be paired.