2010 Chevrolet Traverse Owner's Manual - Page 375

Vehicle Care 11. Press the on/off button (B) to turn the tire sealant and compressor kit off. Be careful while handling the tire sealant and compressor kit as it could be warm after usage. 12. Unplug the power plug (H) from the accessory power outlet in the vehicle. 13. Disconnect the air only hose (G) from the tire valve stem, by turning it counterclockwise, and replace the tire valve stem cap. 14. Replace the air only hose (G) and the power plug (H) and cord back in its original location. 15. Place the equipment in the original storage location in the vehicle. The tire sealant and compressor kit has an accessory adapter located in a compartment on the bottom of its housing that may be used to inflate air mattresses, balls, etc. 10-65 Removal and Installation of the Sealant Canister To remove the sealant canister: 1. Unwrap the sealant hose. 2. Press the canister release button. 3. Pull up and remove the canister. 4. Replace with a new canister which is available from your dealer/retailer. 5. Push the new canister into place. Storing the Tire Sealant and Compressor Kit The tire sealant and compressor kit is located in the storage compartment on the driver side, at the rear of the vehicle.