2010 Chevrolet Traverse Owner's Manual - Page 241

Infotainment System 3. Say the name tag of the person to call. . 7-55 Using the Re-dial Command 1. Press and hold b g for two seconds. The system responds with "Ready" followed by a tone. 2. After the tone, say "Re-dial". The system responds with "Re-dial using " and dials the last number called from the connected Bluetooth phone. Once connected, the person called will be heard through the audio speakers. Call Waiting Call waiting must be supported on the Bluetooth phone and enabled by the wireless service carrier to work. . If the system clearly recognizes the name tag it responds with "OK, calling, " and dials the number. If the system is unsure it recognizes the right name tag, it confirms the name tag followed by a tone. If the name tag is correct, say "Yes". The system responds with "OK, calling, " and dials the number. If the name tag is not correct, say "No". The system will ask for the name tag to be re-entered. . Press b g to answer an incoming call when another call is active. The original call is placed on hold. Press b g again to return to the original call. To ignore the incoming call, continue with the original call with no action. Press c x to disconnect the current call and switch to the call on hold. . . Receiving a Call When an incoming call is received, the audio system mutes and a ring tone is heard in the vehicle. . . Once connected, the person called will be heard through the audio speakers. Press b g and begin speaking to answer the call. Press . c x to ignore a call.